Extreme Picture Finder 3.65.0 downloading

AGC-3 could reboot after CAN protocol change, if there was active CAN communication on the CAN line during the protocol change.Multimains MB fail control of 'Start engine' selection now used in AMF sequences.After MTU has released a new software for the SMART CONNECT module, the alarm 'AL Speed Demand Failure' was always present due to a change in timeout changed from ~40m => ~10m.When LTO is activated with no Sync to mains a delay is added to ensure that multimains status has been evaluated, before it is determined if MB should open.Parameter 3410 relay A setup corrected, so display shows correct value.AGC Mains MB opens unwantedly - corrected.Faulty situation where the AGC-3 could reboot unexpectedly has been prevented (occurred only with Option N).Genset could start when SEMI button was pushed and no start signal had been given (occurred only with Option V0108 German display only).Start enable was required to be energised, if used, to activate the breakers - corrected.Under AMF applications where a second mains fail occurs with at least one DG running and power cap overrule enabled, the timer is now reset (started over again) when DGs are ready and synchronised.Under AMF applications where a second mains fail occurs with at least one DG running, the remaining DGs are now started with a multi start.Support of CAN bus hardware 'Option H5/H8.8 HW v2' requires mainboard 'uP 8 PCB'.Support of CAN bus hardware 'Option H8.2 HW v2' requires mainboard 'uP 8 PCB'.The main changes implemented since the last version are as follows: New features: This software applies to the following DEIF products:

Extreme Picture Finder 3.65.0 downloading